DESCRIPTION
A high performance two pack U.V. stable acrylic urethane with outstanding durability, providing a finish with maximum gloss and colour retention.
USES
As an anti-graffiti coating and for areas of special finish. e.g. handrails, food preparation areas, car parks, petrol stations and any other surfaces which require a high resistance to solvents.
FEATURES
Excellent colour retention
Excellent abrasion resistance
Can be recoated
Suitable for interior and exterior surfaces
Will not yellow
TECHNICAL DATA
Colour Clear, black, white, and other colours available on request
Finish Full gloss, satin and matt
Volume Solids 40%
Specific Gravity 0.99*
Chemical Resistance Excellent
Flash Point 23°C
PREPARATION
General
Do not apply if temperature is below 10°C or above 35°C
Do not apply if rain is imminent
Not recommended for below grade waterproofing
New concrete should be a minimum of 28 days old before application commences.
All holes and cracks are to be repaired prior to coating
The surface to be treated should be clean and sound, free
from oil, grease, flaking paint, laitance and materials deleterious to the
adhesion of the coating system.
Concrete
If surface is porous, prime first with AP Glazecoat let down 20% with Westox AP Glazecoat Thinners, applied at the rate of 6 to 8 m² per litre.
Allow a minimum of 4 hours before proceeding with topcoat.
Metal
Prior to
application, ensure that the surface is intact, free from contaminants such as
oil, grease, water etc.. All damaged
areas should be made good with primer, use a propriety zinc rich epoxy as
primer/undercoat.
Timber
Fill and
sand all holes and defects. Remove
dust. If clear finish required, thin
first coat with Westox Thinners at 50% and apply as sealer, followed by two
coats of AP Glazecoat Clear.
APPLICATION
Mixing
Mix all of base (Part A) with all of hardener (Part B), or
in the ratio of four(4) part A to one(1) part B by volume of small
requirements. Use a power mixer for a
minimum of 1 minute. Allow to stand
10-20 minutes before using. Pot life up to 8 hours working time.
Brush or Roller
Use brush for small difficult areas. Roller is recommended for small to medium
areas.
Spraying
Conventional (pressure 300-450kPa) or airless (pressure
14-17 Mpa) equipment set up
Thinning
Use Westox
Thinners up to 25% volume for conventional spray and up to 15% volume for
airless spray.
Application may be undertaken at the coverage rate of 10m² per litre, per coat (2 coats required) allowing a minimum of 2 hours drying time between coats. Material will be touch dry in 30 minutes and print free in 4 hours.