WX Colourcote Antiflash

DESCRIPTION

A single pack, waterbased anticorrosive coating that can be applied over galvanised metal surfaces, or aged colourbond.

USES

A surface coating for new or existing galvanised metal sheeting to enhance the character and life of the metal.  A cross linker (hardener) is combined to provide a long life coating.

FEATURES

Excellent gloss retention
Excellent adhesion
Easily applied
Economical to use
Can be overcoated
U.V. stable, excellent colour retention
Wide colour range

TECHNICAL DATA

 Volume Solids                       50% +/- 1
 Specific Gravity                    1.13 +/- 0.05
 Flash Point  Not applicable
 Finish             Gloss
 Touch Dry @ 20°C               5 minutes
 Full Dry          1 hour

PREPARATION

Do not apply coating if temperature is below 10°C or above 35°C.
Do not apply coating is rain is imminent.
Sound paint may be overcoated.

New surfaces

Apply a degreaser or solvent wipe all new galvanised surfaces to remove pressing oils etc.
Wash off and allow to dry before commencing application.

Old surfaces

The surface should be treated, should be clean and sound, free from oil, grease, flaking paint, laitance and materials deleterious to the adhesion of the coating system.
To areas of excessive rust, apply one(1) coat of a proprietary brand zinc rich primer and allow to dry.  Ensure that all fixings are properly secure.

APPLICATION

Application is by brush, roller or spray to prepared, pre-primed surfaces at the rate of 5m² per litre.  Apply a second coat at the rate of 5m² per litre, following a minimum 4 hour drying period.

CLEAN UP & PACKAGING

Wash all equipment in fresh water immediately after use.
Container Size 10 Litre & 20 Litre containers