Plastalite High Build Repair Mortar

DESCRIPTION

Plastalite High Build Repair Mortar is a one component, cement based repair mortar.

USES

Formulated for repairs to horizontal vertical and overhead concrete and masonry.

FEATURES

  • Easy application in layer up to 80mm thick
  • Pre-packed
  • Non Corrosive 
  • Lightweight
  • Non Toxic 

TECHNICAL DATA 

 Working Time  30 minutes at 20 degrees celcius
 Minimum Build  5mm
 Maximum Build  80mm
 Compressive Strength  10Mpa – 7 days             20Mpa – 28 days

PREPARATION

All concrete or mortar must be sound and free of loose material laitence or any contaminants

All steel reinforcing shall be rust free and appropriately treated to remove scale and coated with Westox CR25/cement (Refer separate Data Sheet).  Absorbent substrates must be thoroughly dampened prior to application.  The surface must be damp with no free water.

MIXING

Gradually add Westox High Build to required amount of water and mix to a smooth workable lump free consistency.  The over use of water may cause slumping.

PRIMING

A slurry or Westox CR25/cement is to be applied to the dampened surface and the high build mortar is to be applied while the slurry is still wet.

APPLICATION

Apply the mixed mortar by trowel or float to the primed surface.

CURING

Plastalite High Build is formulated to cure under normal conditions.  If applied in high temperatures or windy conditions a curing agent/primer in the form of Westox WB30 could be used.  The covering of the area with plastic sheeting may also assist the curing process to avoid shrinkage.          

FINISHING

A float and sponge finish may be achieved.  A finish coat of Plastalite fairing coat may be used to achieve a smooth surface.

PACKAGING

Plastalite High Build Repair Mortar is supplied in 15kg bags.

SAFETY

Refer to Westlegate Pty Ltd Material Safety Data Sheet (MSDS) for instructions. 

The information contained on this site is intended to give a fair description of the products and their capabilities under specific test
conditions.It does not constitute an offer by the manufacturer, nor does the manufacturer warrant or guarantee its accuracy or
completeness in describing the performance or suitability of the various products !