For the best possible results, use Westox quality products!

HOME ABOUT US PRODUCTS & SERVICES PROJECT GALLERY NEWS CONTACT US


 

Waterproofing WB25 Epoxy

 

Heritage Restoration
Architectural Coatings
Waterproofing
 

 

 

WB Silane
WB30 Epoxy
WB25 Epoxy
Wet Area Membrane
CR25
Interproof
Salt Retarder

 

DESCRIPTION

WB 25 Epoxy is a clear two-part water based epoxy.

USES

WB 25 Epoxy can be used as a Primer / Binder & Sealer or Concrete Repair Mortar.

FEATURES

  • Can be applied to damp surfaces
  • Binds concrete surfaces
  • Seal surfaces from oil, grease and dirt.
  • May be overcoated

SURFACE PREPARATION

All surfaces to be treated must be structurally sound, clean and free from previous coatings, adhesives, dirt, grease, oil or other surface contaminants.  Very dry and highly porous surfaces should be sprayed with a fine mist of water prior to application of WB 25 Epoxy.

MIXING

Mix the hardener component, then the resin component, then thoroughly mix 1:1 by volume, the required amount of the two components together in a separate, clean container.  Preferably use a power stirrer for mixing.  Only mix as much as may be used within the pot life of the product, avoid excessive aeration.

APPLICATION

  • Do not apply if temperature is below 10’c or above 35’c.
  • Do not apply if rain is imminent.

Concrete Sealer (Interior)
Dilute mixed product by 50% i.e. 20 litre kit and 10 litres of water.  Apply with a long nap roller, 2 coats and approximately 8m2 per litre coverage. (Will vary depending on texture)
Concrete Repair Mortar
Mixture is to comprise of 1 part cement, 3 parts sand to 1 part by volume of WB 25 Epoxy.

BONDING

WB 25 may be used as a bonding agent prior to the application of the repair mortar.

LIMITATION

Wet weather and Ponding should be avoided when using WB 25 as a sealer.  WB 25 is not recommended for use in exposed sunlight.

DRYING

Allow to cure for a minimum of 24 hours at 25°c/50% R.H before applying adhesives, mortars, or decorative coatings.  Allow longer for lower temperatures or higher humidity.

CLEANING

Wash all equipment in fresh water immediately after use.

SAFETY

Refer to Westlegate Pty Ltd Material Safety Data Sheet (MSDS) for instructions

   

The information contained on this site is intended to give a fair description of the products and their capabilities under specific test

conditions.It does not constitute an offer by the manufacturer, nor does the manufacturer warrant or guarantee its accuracy or

completeness in describing the performance or suitability of the various products !


.

© 2012 Westox-Nordic Building Products Säbygatan16. 26133 Landskrona - Sweden Tel: +46 704922990 
 
 Webdesign 2012
©  B-Nilsson - x-design.nu - Sweden. All rights reserved.

.