For the best possible results, use Westox quality products!

HOME ABOUT US PRODUCTS & SERVICES PROJECT GALLERY NEWS CONTACT US


 

Waterproofing Interproof

 

Heritage Restoration
Architectural Coatings
Waterproofing
 

 

 

WB Silane
WB30 Epoxy
WB25 Epoxy
Wet Area Membrane
CR25
Interproof
Salt Retarder

 

DESCRIPTION

Plasticising and waterproofing admixture which is added to concrete and/or mortar mixes to form a permanent water repellant lining of calcium stearate in situ, on the walls, pores and voids of concrete mixes.

USES

In concretes, renders and mortars, above and below ground level, to assist in making water resistant areas, such as basements, tanks, lift wells, tunnels, planterboxes etc.

FEATURES

  • Rapidly dispersible
  • Improves workability
  • Increases durability of concrete 
  • After trade bonding not affected
  • No significant strength reduction in concrete

TECHNICAL DATA

 Specific Gravity at 25'c  approximately 1 -13
 pH  approximately 10.0
 Flash Point  Not applicable

PREPARATION

All surfaces to which the render is to be applied must be structurally sound and clean.  Old concrete basework must be revealed by scrubbing.  New concrete and brickwork must be scabbled and wire brushed with joints raked.  Thoroughly wet the area to be rendered and ensure that premature drying out, of the surface does not occur.

APPLICATION

Interproof is added to mixing water at the rate of 1 litre (Interproof) per 30 litres of water.  Use 3 parts plastering sand/1part cement and mix thoroughly.

SPECIFICATION

All concrete to be waterproofed shall be a minimum of 20 MPa design and shall be integrally waterproofed by the addition of Interproof as supplied by Westlegate Pty Ltd used in strict accordance with the printed instructions.

CLEAN UP

Clean all tools and equipment with clean water immediately after use.

PACKAGING

Container Size: 5 Litre & 20 Litre containers.

PRECAUTIONS

Where surfaces are to be tiled, avoid the use of excess Interproof and excessive floating or trowelling.  The proper use of Interproof will give durable water resistance to a relatively high pressure of water, however such applications are not impervious to water vapour.  Avoid excess water in mixes, otherwise shrinkage cracks, water permeability and defective bonding will result.  Avoid repeated and prolonged skin contact with Interproof.

SAFETY

Refer to Westlegate Pty Ltd Material Safety Data Sheet (MSDS) for instructions.

   

The information contained on this site is intended to give a fair description of the products and their capabilities under specific test

conditions.It does not constitute an offer by the manufacturer, nor does the manufacturer warrant or guarantee its accuracy or

completeness in describing the performance or suitability of the various products !


.

© 2012 Westox-Nordic Building Products Säbygatan16. 26133 Landskrona - Sweden Tel: +46 704922990
 
 Webdesign 2012
©  B-Nilsson - x-design.nu - Sweden. All rights reserved.

.