Incellcoat

DESCRIPTION

Westox Incellcoat is a water based, high build, flexible, insulative coating for use on surfaces where temperature control is required.

USES

Factory roofs, farm buildings, mobile homes, silos, shopping centres and hospital roofs, fibrous cement.
Most wall surfaces where internal temperature needs to be controlled for either more efficient air conditioning or general insulation.
Air conditioning duct coating.

FEATURES

Westox Incellcoat is designed to provide a durable, insulative and weatherproof system for use in a variety of areas:

– Fast application.
– Excellent expansion and contraction
– Top coat available in wide colour range
– Acrylic based, non toxic
– Vapour permeable

TECHNICAL DATA

 Pigment Volume Concentration
(PVC)                                          61
VOC                                           38
Volume of solids                  64.5%             AS 1580-301.2-90
 Tensile Strength                   2.27 Mpa       ASTM D 2370-83
Chemical Resistance           Good               ASTM D 2371-88

Water Vapour Transmission                     6.114 gms m2 – 24 hours ASTM E 96-98
Bend Test                               Pass                  AS 1580.402.1-92
Spread of Flame                   0                        AS 1530.3-1989

INSULATION DATA

Heat Transfer Test
(a)   One chamber coated with 600um Incellcoat
(b)   One chamber lined with R-2.5 insulation batts 75mm thick.

AVERAGE READING RESULTS FOR TEST ONE AND TWO

 Test One                                 Test two   
 Ambient Laboratory          25.6°c               Ambient Laboratory          25.6°c 
Coated Chamber               26.7°c              Insulated Chamber             27.6°c
 Bottom Chamber              52.2°c               Botton Chamber (Uninsulated)               52.2°c

VARIATION ABOVE LABORATORY AMBIENT

 Chamber (a)                           1.1°c  – 1.6°c 
 Chamber (b)                          2.0°c  – 3.9°c

The summary of these tests showed that the 600 micron coating had better insulation by 0.9°c to 2.3°c than the insulation batt.

PREPARATION

The surface to be treated should be clean and sound, free from oil, grease, flaking
laitance and materials deleterious to the adhesion of the coating system.
All cracks exceeding 2mm in width are to be repaired before application commences.
Sound paint may be overcoated.
New concrete should be a minimum of 28 days old before application commences.

– Do not apply if temperature is below 10°c or above 35°c.
– Do not apply coating if rain is imminent.
– Not recommended for below grade waterproofing.

APPLICATION

Application by roller or spray to prepared and pre-primed surfaces.

PRIMING

 Steel                         Application by roller or spray to prepared and pre-primed surfaces.              Anti corrosive primer as per manufacturers specifications
 Previous Uncoated             Westox Highblock C, Westox WBA Primer
 Fibro and Concrete             Westox WB30 Primer, application as per Westox TDS

APPLYING INCELLCOAT

Apply at the rate of 1m2 per Litre.

Final Coat

After a minimum drying time of 12 hours, apply Westox WBA at the rate of 2m2 per Litre.

CLEAN UP

Clean up all equipment in fresh water, immediately after use.

PACKAGING

Container Size – 15 Litre containers.