Creteseal

DESCRIPTION

Creteseal is a one component penetrating acrylic sealer / binder.

USES

As a sealer / dustproofer for concrete and cementitious floors.
Ideal for carparks, warehouses etc.

FEATURES

  • Single component
  • Excellent adhesion
  • Chemical resistant
  • Abrasion resistant

PREPARATION

  • Do not apply if temperature is below 10°c or above 35°c.
  • Do not apply if rain is imminent.

The surface to be treated should be clean and sound, free from oil and grease or any existing coating or sealer, and materials deleterious to the adhesion of the Creteseal.  New concrete should be a minimum of 28 days before application commences.  All repairs to the concrete should be made prior to the application of the coating.

APPLICATION

For dustproofing and surface hardening of concrete.  Apply two coats of Creteseal at the rate of approximately 10m² per Litre.  Allowing a four (4) hour drying time between coats.  The coverage rate will vary on the porosity of the concrete.  Product can be applied with either brush, roller or airless spray.

CLEAN UP

Wash all equipment with fresh water immediately after use and before material has dried.

PACKAGING

Container Size – 10 Litre and 20 Litre containers.

SAFETY

Refer to Westlegate Pty Ltd Material Safety Data Sheet (MSDS) for instructions.


The information contained on this site is intended to give a fair description of the products and their capabilities under specific test
conditions.It does not constitute an offer by the manufacturer, nor does the manufacturer warrant or guarantee its accuracy or
completeness in describing the performance or suitability of the various products !